flexible-pipe-with-stainless-steel-braid

HOSES WITHOUT BRAID in stainless steel AISI 321 BARE (ST) OR WITH SINGLE BRAID (CT) in AISI 304 stainless steel, used for conveyance of fluids - resistant to temperatures from - 270 ° C to 500 ° C.

LEGEND: ST type = WITHOUT BRAID CT = WITH BRAID ST / CT see table

Flexible hoses with stainless steel braid

HOSES WITH SINGLE STAINLESS STEEL BRAID TYPE:

AISI 304-316 - 321

stainless steel pipes

AISI 304 stainless steel sleeves for the conveyance of fluids - Resistant up to 600 ° C


Hoses with single braid in stainless steel

The nominal pressure (PN) indicated in the tables is the maximum permissible operating pressure at room temperature in a static position. The burst pressure is 4 times higher than the maximum allowable pressure; the test pressure must not exceed 1.5 times the maximum allowable pressure; the radius of curvature is the minimum possible without internal pressure at room temperature.

AISI 304 stainless steel sleeves used for the conveyance of fluids

HOSES WITH DOUBLE STAINLESS STEEL BRAID TYPE AISI 304- 316-321 SLEEVES IN AISI 304 useful for conveying fluids - resistant up to 600 ° C

Double braided stainless steel tubing Type AISI

The nominal pressure (PN) indicated in the tables is the maximum permissible operating pressure at room temperature in a static position.

Double braided stainless steel tubing Type AISI

FITTINGS FOR METAL PIPES

Metal pipes are normally supplied with different fittings on the basis of compatibility with temperature, the fitting material and the type of end required: threaded, flanged, etc.

FIXED OR REVOLVING FEMALE FLANGE
MF MALE FIXED
TURNING OR FIXED FLANGE


Maximum operating temperatures: Electric welding TIG 690 ° C BRAZING- 290 ° C - fittings in malleable cast iron 300 ° C fittings in carbon steel 395 ° C - stainless steel fittings AISI 304 690 ° C

For correct installation
avoid:

  • TWISTING ON AXES OR ANGULAR MOVEMENT
  • EXCESSIVE BENDING
  • LETTING THE TUBE FALL
  • INCORRECTLY SIZED: OR TOO SHORT OR TOO LONG
  • ALLOWING THRUSTING MOVEMENTS
Share by: